Dr Desmo Bar Riser Kit for ST2, ST4 and ST4s models available in 3 different heights [1/2", 3/4" or 1"]. These can be installed so the bars sit as per original or swept back 7.5 degrees for a more relaxed and natural angle on your wrists. Each kit comes with 2 spacers and 8 stainless fasteners. You can use the OEM rubber brake hoses and they work with both types of master cylinders found on these bikes. PLEASE NOTE: If the fork tubes have been raised above the top triple clamp from the stock position, (front end dropped for quicker handling), these risers will not work!!!
Specially modified 1" risers are available for a small surcharge.

these are fully adjustable clip-ons made by Tommaselli. If you want a clip-on, but prefer a bit of a rise then these bars are for you. Lower than a flat bar, higher than a regular clip-on, they are favorites for SPORT or SUPER SPORT owners who really don't like to be so leaned over... A well made aluminum bar that rotates and pivots to adjust to your preference.

Nice alternative for a complete clutch lever assembly features black perch and black dogleg lever. This unit does not have a mirror mount.

This is a complete clutch perch assembly with lever. It is all black with a dogleg lever - fits all bevel drives. I less expensive alternative but a nice unit none the less.  NOTE: The rubber cover is no longer included from the manuf.

125mm long DUCATI grips fit standard 7/8" bars. Commonly found on Ducati singles in the 50's and 60's these will finish off that perfect restoration or, put em on your modern bike... These can be ordered either CLOSED ENDS (as shown) or with OPEN ENDS for running bar end mirrors.

These are KEWL natural gum looking but newly made grips, like the old Tommaselli Daytona grips. They are opaque brown. They feature a nice cross hatch texture pattern and the throttle grip has a ridge on it to help you control the throttle. Position the ridge and the second joint of your fingers so it is nice and comfortable. These are newly made using new technology so they will last.

Tommaselli black grips with that vintage look - these are exactly what you get when you buy a DAYTONA 2C throttle now... They are VERY close to what was on a Darmah etc originally. Newly made by Tommaselli.

Grey open end grips made in Italy by ARIETE. We like the feel of these grips....

OPEN ends

CLOSED ends

Right side handlebar switch with STARTER BUTTON plus ENGINE KILL button. This is a very high quality unit which measures 25mm wide and fits standard sized bars. The RED button on top is your RUN/OFF switch, it is fixed in either position. The black button on the bottom is your momentary starter button - press and hold it as long as it takes, release to disengage. The pigtail is 600mm long to the included mystery plug. There is no wire diagram so a bit of forehead scratching will be in order to figure out which wire does what. When we have time we will do this and add the info here. Can't be that difficult as there are 4 wires in the plug for the 2 switches plus a ground wire outside the plug.

This is a DOT approved handlebar switch assembly which features a turn signal switch, headlight HI/LOW and a passing lever [toggles low to high etc] which can be used as a kill switch as well. IT also has a horn button, and LED indicator. The wire length is 14", 6 amp switch 6V to 14V, overall width is just over 51mm.

This is a simple ON OFF switch that can be mounted to standard size handlebars and comes with a 20" pigtail and an assortment of connectors. The switch itself measures 22mm wide and can be used for any number of tasks such as turning lights on or off, engine kill button etc.