 |
Club Bevel Heaven
<~> Ducati Restoration Forum <~>
|
| View previous topic :: View next topic |
| Author |
Message |
djavorek
Cucciolo - the Lil Pup
Joined: 10 Jan 2010
Posts: 2
Location: Beachwood, Ohio USA
|
 Posted: Sun Jan 10, 2010 12:50 pm Post subject: 1970 350 Scrambler rear fork (swingarm) disassembly |
 |
|
My restoration project is at the point of removing the rear fork (swingarm) on my 1970 350 Scrambler for cleaning & repainting. How does it come apart? Do I loosen the clamp-bolts on each side, and pry out the decorative caps on each side, or what? Is there a pivot shaft that will need to be pounded out, or pins, or pegs, or what?
_________________
Currently rebuilding 1970 350cc Scrambler |
|
| Back to top |
|
 |
djavorek
Cucciolo - the Lil Pup
Joined: 10 Jan 2010
Posts: 2
Location: Beachwood, Ohio USA
|
| Posted: Tue Feb 02, 2010 4:32 pm Post subject: Swingarm removal on 1970 350cc Scrambler |
|
|
The swingarm was successfully removed by pounding the pivot shaft out with a brass bar and heavy hammer. The brass bar is just the right size to match the pivot shaft outside diameter, and yet slide into the I.D. hole of the frame and the I.D. of the bushings in the swingarm. Some penetrating oil on the pivot shaft, and 25 good swings of the sledge popped it out.
_________________
Currently rebuilding 1970 350cc Scrambler |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
